|
 |
|
| |
|
Gasket Type:
TYPE E - Type E gaskets are for full face protection of both flange faces
Specify The Following: (How to Order)
● Specify Gasket Type: D, E, or F.
Recommended Installation Procedure:
● Verify that the installation kits contain the material specified and the contents are not damaged.
● Clean and inspect pipe flange faces and apply lubricant to all threads.
● Install the gasket and align the flanges and gasket so the bolts will be centered.
● Use alignment pins in two diametrically opposite bolt holes whenever possible to assure proper alignment of flanges and gasket.
● Insert insulating sleeves into the bolt holes taking care not to use force which could damage the sleeve material.
● Insert the bolt with both insulating washers against the flanges followed by the steel washer and nut.
● Tighten two diametrically opposite bolts to 30% to total torque.
● Replace the two alignment pins with bolts and tighten the remaining bolts to 30% of the total torque value.
● Tighten all bolts to 50% and the to 100% of final torque value.
● Bolts should be of sufficient length to extend through the nut approximately 1/4".● Specify Single or Double Washer set
● Specify Sleeve Material: Polyethylene, Phenolic, Mylar, or Nomex.
● Specify Flange Size and Pressure Rating
TYPE F - Type F are to fit the raised face surface area of the flanges.
TYPE D - Type D Are made to fit the ring grooves on ring type joint (RTJ) flanges.
SEAL TYPE O - Gasket and O Ring are available in different materials to maintain constant contact with the flange face.
|
|
| New Product |
 |
Polypropylene Tellerette 3K
ETFE +25% Glass Tri packs 2inch
|
| |
|
|
|
|
| |
|
Deutsch
Español
Français
Italiano
Português
日本の
한국어
العربية
български
hrvatski
česky
Dansk
Nederlands
suomi
Ελληνικά
हिन्दी
norsk
Polski
Română
русский
Svenska